1. The message, "Time out" is displayed in the LCD when you could not identify?

There might be one of the two reasons due to which this problem might arrise.Both the cases and its solutions are discussed below.

Case 1> "Time out" is displayed after the sensor went on the state of "Blinking".

Check following things:

1.The state of your fingerprint is dry.So, the sensor cannot scan the image of your fingerprint in time.

2.You have to check if your finger departs from the sensor before capturing the image.


If above mentioned following things are checked and are proper then pls try following things:

1. Retry to identify after touching ur Nose.Normally, nose of human is oily.If your hands are dirty, please wash ur hands.

2. Your fingerprint doesn't have to depart from the sensor before capturing image.



Case 2> "Time out" is displayed after the sensor went on the state of "Light-up".

Check following things:

1. The state of your fingerprint is wet. So, the sensor can not read the fingerprint because of a mashed image.

2.Y ou have to check if the strength of pushing when your finger pressed on the sensor is strong or not.


If above mentioned following things are checked and are proper then pls try following things:

1. Retry to identify after using the towel.

2. You have to keep being proper strength when your finger pressed on the sensor.